Date of Original Version

5-2010

Type

Article

Rights Management

Copyright 2010 American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article may be found at http://dx.doi.org/10.1063/1.3350900.

Abstract or Description

We report on new high-saturation induction, high-temperature nanocomposite alloys with reduced glass formers. The amounts of the magnetic transition metals and early transition metal growth inhibitors were systematically varied to determine trade-offs between higher inductions and fine microstructures with consequently lower magnetic losses. Alloys of nominal composition (Fe65Co35)79.5+xNb4−xB13Si2Cu1.5 (x=0–4) were cast into a 28 mm wide, 20 μm thick ribbon from which toroidal cores were wound. Inductions and magnetic losses were measured after nanocrystallization and stress relief. We report technical magnetic properties: permeability, maximum induction, remanence ratio, coercive field, and high frequency magnetic losses as a function of composition and annealing temperature for these alloys. Of note is the development of maximum inductions in excess of 1.76 T in cores made of alloys with the x=4 composition and maximum inductions in excess of 1.67 T in alloys with the x=3 composition, which also exhibit power losses smaller than 10 W/kg at 0.2 T induction levels in 20 kHz fields. We discuss optimization of induction with chemistry and correlate the microstructures with losses.

DOI

http://dx.doi.org/10.1063/1.3350900

Share

COinS
 

Published In

Journal of Applied Physics, 107, 9, 09A316.